Issue with the world wide name on vxdmpadm
Article ID: 100008648
Updated On:
Cause
This is a defect in the vxdmpadm list command that prevents the correct output.
Solution
Engineering has verified that the problem has been identified and the solution will be rolled into the next release.
Version: SFHA 6.0.1 will contain the fix for Linux and SFHA 6.0.5 has fix incorporated for all Unix Platforms
Applies ToStorage Foundation 6.0 / 6.0P1 / 6.0RP1 on AIX, Solaris & Linux Platforms
Issue/Introduction
After upgrading to VxVM 6.0, a port WWN shows as '-' rather than the correct number.
Error Message
ERROR CODE/ MESSAGE:
###path = name state type transport ctlr hwpath aportID aportWWN attr
path = sdd enabled(a) primary FC c1 c1 0A - -
path = sds enabled secondary FC c1 c1 1A - -
The WW Port number is missing from the above output.
Additional Information
ETrack: 2826958
Was this article helpful?
Yes
No
Powered by
