When 'List in the directory' option is selected under printer properties, printer under VCS control does not get listed in Microsoft's Active Directory (AD).
book
Article ID: 100020775
calendar_today
Updated On:
Resolution
This issue has been identified and a private fix is available from Veritas Enterprise Technical Support. To obtain the private fix, contact Veritas Support and reference this article during the call. A support representative will be available to assist in troubleshooting this issue. If it is determined that the private fix addresses the problem, the support representative will further assist in obtaining the private fix.
Note: This fix specifically addresses the problem identified above. It has not been fully tested and should be applied in a test environment before placing into production. If the systems are not critically impaired, it is recommended to delay the installation of this private fix until the next scheduled maintenance release. Before applying this private fix, systems may be required to be upgraded to the latest code base. The support representative will help in determining the best course of action.
Issue/Introduction
When 'List in the directory' option is selected under printer properties, printer under VCS control does not get listed in Microsoft's Active Directory (AD). If the same attribute is changed on a printer outside of VCS control, then the printer is listed in the AD.
Was this article helpful?
thumb_up
Yes
thumb_down
No