VOM is reporting service group and resources that do not exist in VCS configuration
Article ID: 100024150
Updated On:
Description
Error Message
None. Stale resources (RES) which had been deleted from the VCS Service Group (SG) are still visible in the VOM display (Resources or Resource Depenedency tab)
A databse sync did not remove stale entries.
Cause
possibly code defect
Resolution
This issue does not exist when the VOM CS and MH are at version 4.0 or above.
If the installed version is below 4.0 or the inconsistancy occured prior to the systems being upgrade, the following procedure may be used to remove the inconsistant entri(es).
Removal of stale service group(s) and resource(s) from VOM.
1) Create dummy service group in VCS for all stale service groups using HA commands (CLI).
2) Create dummy resource in VCS for all stale resources using HA commands (CLI).
3) Create dependencies among service groups and resources using HA commands (CLI).
4) Execute this command on one of the VCS nodes (which will be an MH and/or CS).
/opt/VRTSsfmh/bin/mh_ctl.pl --family VCS --refresh --context optimize=off
5) Delete dummy service groups using VOM; associated resources and any dependencies will also be deleted.
Applies To
Linxu RedHat 5 update 3
VOM 3.1RP1
VRTSsfmcs-3.1.830.0-0
VRTSsfmh-3.1.830.0-0
While the issue was discovered on a Linux Managed Host (MH) in a Cluster Volume Manager (CVM) environment, the steps above will likely apply to any VCS environment or Operating System (OS) where this issue is observed.
Issue/Introduction
